The floor your garage was always meant to have
Diamond-ground to the substrate, built to spec mil thickness, and sealed against road salt and hot-tire pickup; installed in a day, backed for fifteen years.
A three-layer system, not a coat of paint
Every Resinate garage floor is a measured, multi-coat build installed over properly prepared concrete. That is the whole difference between fifteen years and two.
Diamond-ground preparation
We grind the slab to an open concrete profile, chase and fill every crack, and moisture-test before a drop of resin goes down.
High-solids epoxy base & flake broadcast
A pigmented 100%-solids basecoat, broadcast to refusal with decorative flake in the blend you choose from our showroom samples.
UV-stable polyaspartic topcoat
A clear industrial wear layer that shrugs off road salt, oil, and hot tires; and never yellows in the sun. Walk-ready the same evening.
Built to numbers, not to eye
20+
Mils dry-film thickness
100%
Solids epoxy base
1 day
Typical installation
15 yr
Workmanship warranty
Pick the floor, not just the colour
Flake blends, metallic pours, and solid colours; every sample below is a real Resinate install, not a catalogue render.
Full-flake broadcast
Metallic pour
Flake up close
Garage floor questions, answered straight
-
Most two-car garages are ground, repaired, coated, and flaked in a single day. The polyaspartic topcoat is walk-ready the same evening and takes vehicle traffic after 24–48 hours.
-
Not on a properly prepared floor. Hot-tire pickup happens when coatings sit on sealed or dusty concrete. Because we diamond-grind to an open profile and use a 100%-solids base, the bond is mechanical; and covered in writing for 15 years.
-
Usually, yes. Crack-chasing, spall repair, and oil-stain remediation are part of our standard prep. Severely damaged slabs may need resurfacing first, which we also do in-house.
-
A dust mop and the occasional wet mop with a neutral cleaner. The floor is seamless and non-porous, so salt, oil, and slush wipe up instead of soaking in.